Easy Operation Automatically Cuts Excess Edge Mat | RFQ Sourcing Details

Product Features • Touch screen + PLC to control tool gap and working process. • Servo motor + ball screw control roller to square tool gap according to plate thickness • Each corner can be identify different inner radius according to thickness • Forming the R angle does not require open angle welding.

It only needs to pre-bend the two sides of the R angle by 90 degrees on the bending machine, and then roll and form the whole machine on this machine to automatically cut the excess edge material • The die types are divided into bending lower die, forming roller upper die and forming lower die.

The bending die is the same as the ordinary bending die, depending on the thickness of the plate. The upper die of the forming roller depends on the R angle that needs to be formed. The forming lower die is determined by the R angle of the upper die of the roller minus the thickness of the plate.

A lower die has four different R angles • The forming R angle is the same but the plate thickness is different.

It is not necessary to replace the forming roller upper die and forming lower die, only to adjust the gap between the forming roller upper die and the forming lower die Product Parameters Model CF-3050 Total Power 5.5KW Voltage 3. Phase 4. Wire 220V/380V Oil Pump Power 3.7KW 380V Air Pressure ≥0.8.

Mpa Processing Capacity Material Plate Thickness Flange Height Corner Radius Cold Rolled Steel Plate 0.6mm ≤10mm INSIDE:R2-R50 OUTSIDE:R0.8-R49 0.8mm ≤15mm 1.0mm ≤18mm 1.2mm ≤20mm 1.5mm ≤22mm 2.0mm ≤25mm 3.0mm ≤30mm Stainless Steel 0.8mm ≤10mm 1.0mm ≤15mm 1.5mm ≤22mm 2.0mm ≤27mm Aluminum Plate 0.8mm ≤15mm 1.0mm ≤18mm 1.0mm ≤22mm 2.0mm ≤25mm 2.5mm ≤27mm 3.0mm ≤30mm Weight 2600kg Workpiece Size Minimum 200*200mm Maximum 6000*6000mm